Rattle

[BadJoey]

I'm getting a rattle from the bell housing area . It happens right at 3500 RPM's every time . It stops if I push the clutch in . Everything is new . I haven't dropped the bell cover to look for the problem yet , hopefully Monday . I wonder if it is the trow out bearing (not a bad bearing , rattle) ? I tried picking up the peddle with my foot but the noise did not change . All I can think of is the bearing vibrating against the pressure plate arms , but then why wouldn't it stop when I picked up on the peddle . Any ideas are more then welcome . Clutch is not slipping and I do not think it is major .

[Chryco Psycho]

do you have a spring on the release lever to a load on it , it hooks the lever & the corner of the belhousing

[Moparal]

Do you have a bushing or pilot bearing installed in the back of ther crank for the input shaft in the trans?  Is your trans gear oil level low?

[BadJoey]

I can not remember putting a spring in . I do remember checking for the pilot bearing (tore up a clutch like that as a kid) oil is full as well . I am on the way out now (other things on the list for today) but i will be under the car tomorrow for sure . Thanks guys .

[dodj]

do you have a spring on the release lever to a load on it , it hooks the lever & the corner of the belhousing

There is a notch in the fork where the spring should be.

[BadJoey]

Is this spring inside or outside of the bell housing ? 

[Chryco Psycho]

outside , connects inth ethe slot in the fork & the hole in the bottom corner of the belhousing

[BadJoey]

I know I do not have a spring there and that is probably my noise . When I got the car everything came in boxes so I had to feel my way through things . Thank goodness and cc.com . You guys are the best . THANKS !!!