moog idler arm instructions

[1black71rt]

I have a moog k7041 idler arm and no instructions. There are two soft seals and a washer. I know the bolt goes up from the bottom but does the washer go on top or bottom of the idler arm? Does any one have the instuctions for this? 

[Changin Gears]

The washer may also go under the nut on the tapered side that goes through the center link, if you run out of threads.

[1black71rt]

I think the washer goes inside the k-frame mount. It is to loose without it. I don't know if it goes on top or on the bottom. Thanks 

[Chryco Psycho]

I have used the washer on top of the idler to add clearance  keep the tie rod ends away from the T bars , the small foam washers go on the top & bottom of the idler inside the K frame munt , the larger foam washer goes between the idler & center link

[1black71rt]

So when you put the idler in the k frame mount you put the washer inside on top?  You would think it would have washer on both sides in the mount but it only comes with one.

[Changin Gears]

I've used the washer to correct bump-steer issues.  I've even cut the sleeve shorter so I could install 2 washers on one side.