Need a measurement

[mcgheejt]

I need the correct placement of the 340 four barrel emblems on the buldge hood of a 71 Challenger.  Since the engineer drawings are no longer available, could someone perhaps take a pic of their car with a ruler or tape measure so I can get it centered properly?

Thanks in advance. 

[wagesofsin]

I need the correct placement of the 340 four barrel emblems on the buldge hood of a 71 Challenger.  Since the engineer drawings are no longer available, could someone perhaps take a pic of their car with a ruler or tape measure so I can get it centered properly?

Thanks in advance.

you dont have any holes?

[mcgheejt]

No holes on the repop hoods.  Lot's of threads asking for info on different badges 440, 44 6pak, etc but none show either the placement of the 340 with a measurement or the placement of drilling the holes. 

[wagesofsin]

No holes on the repop hoods.  Lot's of threads asking for info on different badges 440, 44 6pak, etc but none show either the placement of the 340 with a measurement or the placement of drilling the holes.

ok, if you run a tape from the back of the hood on top of the bulge, the end of the "l" is 18 and 1/4 from the edge.
emblems about 1" down of the top of the bulge.




if you need more detailed specs, pm me and ill give you my number.