'73 Challenger long brake line routing...

[Strawdawg]

I am replacing all the brake lines on my '73.

On the long line that runs from the bottom of the proportioning valve down and along the longitudinal frame rail to the rear of the car and the hose that "y"s to feed the two axle lines...........

The one that was on the car was not routed properly and had only a couple of clamps on it.  I yanked it off without paying much attention to how it was routed in the mistaken belief that it would be obvious as to how the new one would fit.  It's not 

Does anyone have any pictures from the bottom side showing how the line should fit to the frame rail as it comes down from the valve as well as locations of the various clamps along the way and the route  behind the tire as it goes back to the hose?

I would greatly appreciate it.  thanks!

[Bullitt-]

see my contribution on page-1
http://www.cuda-challenger.com/cc/index.php?topic=62801.0

[Strawdawg]

That helps...still need the one in front of the cross member where the line goes up to the proportioning valve...got lotsa bends but  I can;t figure out how it lays agains the rail

I appreciate it...now I can sort out the rear once i have the front....  sure missing a bunch of clamps

[Strawdawg]

I think I probably have it figured out...found a mark where a clamp originally was.  The rear pics really helped as the line was just hanging back there and not routed at all.  thanks!