News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: 489 vs 742 Yoke?  (Read 611 times)

    Offline Glennster

    • Full Member
    • ***
    • Posts: 879
    489 vs 742 Yoke?
    « on: August 20, 2010 - 09:47:01 PM »
     I just got my 489 Pig installed. When I went to bolt the drive shaft to the Yoke I found that it was 1/2'' wider than the Yoke on my 742. I never thought to measure them....Another rookie mistake.

     Will the 742 Yoke fit in the 489 Pig?
    Logged


    Offline FJ5_440

    • Full Member
    • ***
    • Posts: 879
    • Wisconsin
    Re: 489 vs 742 Yoke?
    « Reply #1 on: August 20, 2010 - 09:55:18 PM »
    It would bolt right up if you get a "conversion" U joint.
    Logged
    ** Shane **

    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: 489 vs 742 Yoke?
    « Reply #2 on: August 20, 2010 - 11:55:58 PM »
    I would just get the Precision conversion joint , , it is the easiest fix , it is possible to swap the yolk maybe but there are 2 different splines & you upset the crush on the crush sleeve pressure removing from the 489 so I would leave it alone
    Logged

    Challenger - You`ll wish You Hadn`t

    Offline Glennster

    • Full Member
    • ***
    • Posts: 879
    Re: 489 vs 742 Yoke?
    « Reply #3 on: August 21, 2010 - 07:06:59 AM »
     Thanks!
    Logged
    Pages: [1]
    « previous next »