windshield trim screws are they phillips head or hex?

[Barracudadan]

I have a couple rusty hex head screws with a fine thread holding on my windshield trim the lower piece with 4 screw holes in it down by the wiper blades. Are these correct? If not what type of fastener goes there? Shouldn`t they be chrome plated or stainless steel to prevent rusting with maybe a Philips head instead of hex head? These don`t look like the right screws that belong there they look like those small screws that bolt the grill on. If anyone has a picture of this area showing the fasteners it would be appreciated!Thanks!

[Moparal]

phillips

[burdar]

They should be chrome plated phillips head screws with a built in washer.  Not a loose spinning washer but one that is part of the screw itself.  The phillips head is rounded and then the washer area flattens out.  Did that make sence?  I tried searching for one on R/T Specialties website but there's too much stuff to look through.

[Barracudadan]

Wow fast replys thanks guys. I didn`t think what was there was right.Yes Burdar that does make sense I should be able to find something close to what you described.

[Moparal]

my dodge truck has the same, but not chrome