will these pushrods fit?

[willard]

Finally I measured my pushrods and they are 0.125" too long. I found this auction:
http://www.ebay.com/itm/350585996044?item=350585996044

I guess these are gonna fit my 383 with stealth heads and lunati lifters with stock rockers?

[brads70]

Too many variables to know for sure? If you know that every pushrod is .125" to long then I would say you can measure what you have and get one 1/8" shorter?
I'd get an adjustable pushrod and check for sure.

[Changin Gears]

I made my own adustable pushrod to check lengh out of some all-thread, a couple of nuts, and an old cut up pushrod...

[willard]

I already checked w/ pushrod checker and I need 8.450". My question was abiut that specific jesel pushrod - it's shaped a bit different than normal ball-ball pushrod.

[Aracer]

I think that an actual, round ball / ball will clear more lift @ the rocker. But you have to determine the durability of the item for your setup. The price seems low enough. One important Mopar thing is the lack of oil hole.

[brads70]

I'm wondering if the ball on the ends are the required radius?

[willard]

I have only lunati 220/226 cm with less than 0.5" of lift so nothing fancy needed here.

[Moparal]

If you need 8.450, those Jesel ones will work without any problems.  You must have some shaved heads and a decked block?