News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: Trunk lid torsion bars?  (Read 646 times)

    Offline shoooter

    • Full Member
    • ***
    • Posts: 701
    Trunk lid torsion bars?
    « on: July 31, 2013 - 08:37:08 PM »
    Are trunk lid torsion bars the same on a cuda and a challenger? Will all years cross?
    Logged


    Offline FY1Cuda

    • Sr. Member
    • ****
    • Posts: 1493
    Re: Trunk lid torsion bars?
    « Reply #1 on: July 31, 2013 - 08:48:41 PM »
    Don't have the Cuda handy, but the brackets for the bars in a Challenger are 44 1/4" apart , so if the brackets in your Cuda are anywhere around that, they'll fit.
    Logged

    Offline sprecks

    • Full Member
    • ***
    • Posts: 915
    Re: Trunk lid torsion bars?
    « Reply #2 on: July 31, 2013 - 08:51:40 PM »
    I think the Cuda is a bit shorter. Some Challengers (not sure about Cudas) came with 2 bars and some came with only one bar. The single bar set up was a larger diameter.
    Logged
    you can call me Jay
    I've seen sicker dogs get well.

    1971 Challenger Vert - 472 Hemi EFI
    1969 Road Runner 440/Auto
    2017 Ram Laramie 1500 - Hemi

    Offline Topcat

    • C-C.com Expert
    • ********
    • Posts: 15376
    • Member since 9/16/04
    Re: Trunk lid torsion bars?
    « Reply #3 on: July 31, 2013 - 09:46:04 PM »
    70's that I've seen before had 2 torsion bars.

    Then in 71' they started switching to a one long trunk torsion bar.

    However! I once had a picture of a 71' Cuda vert that had 2 torsion bars.

    Did they use 2 torsion bars when either a Go wing or Luggage rack was optioned on the buildsheet ?
    Logged
    Mike, Fremont, CA.

    Pages: [1]
    « previous next »