Author Topic: fuel line  (Read 761 times)

Offline rattlesnake

  • Rattlesnake
  • Jr. Member
  • **
  • Posts: 431
fuel line
« on: August 18, 2013 - 08:03:48 PM »
Will a 5/16" primary fuel line provide enough fuel for a mildly modified single 4 barrel (holley 850) 440? I am expecting the engine to produce 450 to 500 HP. Should I go to a 3/8" line? Also does anyone know how to make the expanded flare on the end of the fuel line so a rubber hose can be connected to the line to eliminate leaking?

thanks Ray
keep honking I'm reloading




Offline Strawdawg

  • Resident
  • *****
  • Posts: 2209
    • Vortex Buicks
Re: fuel line
« Reply #1 on: August 18, 2013 - 08:37:12 PM »
I would use 3/8's.   Not sure about the flare...I just double clamp them

Offline Chryco Psycho

  • Administrator
  • C-C.com Guru
  • *****
  • Posts: 36620
  • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
Re: fuel line
« Reply #2 on: August 18, 2013 - 09:20:30 PM »
I use a double flare & swell the tube with no sharp edges , slide the hose over & clamp it

Challenger - You`ll wish You Hadn`t

Offline Racer57

  • Sr. Member
  • ****
  • Posts: 1489
Re: fuel line
« Reply #3 on: August 18, 2013 - 10:17:50 PM »
Also does anyone know how to make the expanded flare on the end of the fuel line so a rubber hose can be connected to the line to eliminate leaking?

thanks Ray

Most places like Ace, Home Depot, NAPA,  etc carry the tools required to do it. Their cheap to buy and easy to use.

Offline cudabob496

  • Sr. Resident
  • ******
  • Posts: 8024
Re: fuel line
« Reply #4 on: August 19, 2013 - 01:21:18 AM »
unless you are running the quarter mile full throttle, I would think you 5/16 would be fine.
As long as you got a good fuel pump,and clean fuel filter, you should be ok.
A fuel pressure gauge in the car can really help you know for sure.

Sometimes the fuel sending unit sock filter in the gas tank can clog up.
« Last Edit: August 19, 2013 - 02:37:07 AM by cudabob496 »
72 Cuda, owned 25 years. 496, with ported Stage VI heads, .625 in solid roller, 254/258 at .050, 3500 stall, 3.91 rear. 850 Holley DP, Reverse manual valve body.

1999 Trans Am, LS1, heads, cam, headers, stall, etc! Love to surprise the rice rockets with this one. They seem so confident, then it's "what the heck just happened?"

2011 Kawasaki Z1000