Ok, don't get too excited, but I really do have a set of 4 Power Window regulators that are from a 70 Cuda. Both door units & the rear units have the power motors on them & the special bracket on the motors. Wires not cut. Motors are not tested, but if you make a fuss about if they dont work the cost should be lower, I will NOT sell them to ANYONE! You know you can install another motor for another power window car & go! The regulators do have some rust from being in a box on them but they are not pitted rust, as I believe the box had water dripped on it from a leaky garage. seriously, I can clean this off & nobody will ever know, after all they reside inside behind your panels right??!!
Now the back regulators is what makes me think REAL hard! I have had SEVERAL rear PW units form E-bodys & I KNOW my power window E-body parts. I have had several sets in the past & these are NOT B-body parts. Also, These rears look slightly different from my hardtop units I have in my 72 Cuda, so I thinking these both rear units could be both REAR PW 'CONVERTIBLE ' REGULATORS!
I can provide pictures no problem. I only have the regulators, no switches or wiring. Just the wires on the motors. Cost you ask? Well, this is a once in a lifetime opportunity and I have seen these come up at times, but its rare. I have had these for ages & I know they are rare period!
So understand that I am asking such a high price of $2500.00. If you have a convertible & you need them, just how many of the convertible ebodys had a power window set up & how many of those cars were actually built.
So don't go bragging about someone on here just listed these for this cost.
I am open to offers as well, but don't go low balling me TOO low
, so be reasonable! They don't take up much space in my garage, but I'd rather sell them to someone who is going to USE them on HIS car & not to be sold at a swap meet. Maybe I'm TOO high or maybe I'm TOO low on the cost. But remember, dont use aftermarket junk if your car is coded P31, get whats right for your ride, especially if you want original parts!
if you are building yet another hemicuda convertible clone or a clone with all the options, then these might be for you. You will have to provide your own wire harness from another car & fit them to your ride at your time & cost, unless you happen to have the correct wiring for PW in your ride.
PM me for details,
or you can just e-mail me (put all this into one line, you understand) here at this address: cudamaster7074 at g mail dot com
These can be picked up near my home with a prior arrangement with ca$h in hand, or I seriously prefer a bank check, or postal money orders. Paypal users WILL include the paypal fee. Shipping is extra & insurance should be required & paid by you as well.
Let the fighting begin
.....get them now if you want them before the other guy does!!!!!
