Author Topic: any one know  (Read 921 times)

Offline 6771plymouth

  • john
  • Jr. Member
  • **
  • Posts: 200
any one know
« on: April 02, 2014 - 04:16:23 PM »
passenger side trunk what goes in this hole




Offline MEK-Dangerfield

  • C-C.com Expert
  • ********
  • Posts: 20946
  • I don't get NO respect! Member since 1/25/2002
Re: any one know
« Reply #1 on: April 02, 2014 - 04:25:50 PM »
You don't mention what car or what year.

I'll assume it's a Challenger, and guess it's a hole for some kind of recovery system for the fuel vapors in the fill tube.

If you have a Cuda, then I truly don't even have a guess.    :banghead:

Mike

1970 Challenger - SOLD
2016 SXT+.  1 of 524 SXT+'s in Plumb-crazy for 2016.

Offline anlauto

  • Permanent Resident
  • *******
  • Posts: 12328
  • I'm Alan G...I'm a Mopar Addict
    • Alan Gallant Automotive Restoration
Re: any one know
« Reply #2 on: April 02, 2014 - 04:46:06 PM »
1970-72 Fuel tank vent tube. 70 is different than 71-72 but both Cudas and Challengers had them :2cents:
I've taught you everything you know.....but I haven't taught you everything I know !
www.alangallantautomotiverestoration.com

Offline anlauto

  • Permanent Resident
  • *******
  • Posts: 12328
  • I'm Alan G...I'm a Mopar Addict
    • Alan Gallant Automotive Restoration
Re: any one know
« Reply #3 on: April 02, 2014 - 04:51:48 PM »
1971 Challenger
I've taught you everything you know.....but I haven't taught you everything I know !
www.alangallantautomotiverestoration.com

Offline dfrazz

  • 1970 Cuda - 1968 Charger
  • Resident
  • *****
  • Posts: 4070
Re: any one know
« Reply #4 on: April 02, 2014 - 05:08:31 PM »
It is the hole for your vent tube from the fuel tank.  I'm not sure about Cuda's, but '71 Challengers (and later I believe) required these for pollution control.  There were 4 vent lines mounted inside the vent tube down inside the passenger rear quarter with one or two coming from the fuel tank.  I recently replaced my trunk floor with one from AMD and pulled the vent tube and lines out since the new floor did not have this hole.  I am also running a sending and return fuel line.

Offline dfrazz

  • 1970 Cuda - 1968 Charger
  • Resident
  • *****
  • Posts: 4070
Re: any one know
« Reply #5 on: April 02, 2014 - 05:11:20 PM »
Also that vent tube is capped at the top and does not go anywhere.

Offline 6771plymouth

  • john
  • Jr. Member
  • **
  • Posts: 200
Re: any one know
« Reply #6 on: April 03, 2014 - 01:45:15 PM »
sry its a 71 cuda,  thank you.. kind of wish I dismantled the car so I know were things go but I bought it in this state so its gona be a long project...  8)
« Last Edit: April 03, 2014 - 01:48:58 PM by 6771plymouth »

Offline CudamanTom

  • Resident
  • *****
  • Posts: 2670
Re: any one know
« Reply #7 on: April 03, 2014 - 02:11:23 PM »
sry its a 71 cuda,  thank you.. kind of wish I dismantled the car so I know were things go but I bought it in this state so its gona be a long project...  8)
I'm in the same boat with my vert. Luckily I have a hardtop to refer to on most stuff. Both are projects though.
Bought them both stripped down and some stuff I'm learning what goes where.
I'm so lucky to be a memeber on this forum. If these guys on here don't have an answer, then there isn't an answer to be had.  :2thumbs:
1971 Cuda Vert 440-833 - (clone)
1971 Cuda 440-727 - (clone)


Because I like it fast!!!