Restored my 4 Speed Pedals!

[Roadrunner420]

Blasted, cleaned, new bearings/bushings,
And re-painted.  What do you guys think?  I might strip them all down for clear zinc plating though.

[Topcat]

That's really nice work.
You even have a clutch safety switch. Those are getting hard to get.

[dfrazz]

Those look really nice!

[anlauto]

I use Seymour's Stainless Steel paint...nice stuff and it will never rust again.

[Roadrunner420]

Thanks Guy's,  they took me a bit of time,  but the cost of Zinc is not too bad.  $125 minimum lot fee and a $1 a part.

[tommyg29]

Really nice 
Is that what they looked like new?

[roadman5312]

                        They look awesome.   

[Roadrunner420]

Tommyg29,  yes this is how they should look, but clear zinc instead of paint.  Brewers performance had all new bearings and bushings.  If your missing anything from your original pedals they probably have it.

[anlauto]

Actually from the factory they were never plated or painted. They were left bare steel, and usually rusted.

Yours look great

[Cuda Cody]

You should be proud.  Nice work!   

[Pimtao]

I use Seymour's Stainless Steel paint...nice stuff and it will never rust again.

Where do you get that from?

[anlauto]

Where do you get that from?

My basement

[Pimtao]

My basement

And where did your basement get it from   

[anlauto]

And where did your basement get it from   

Oh...I order it by the case directly from Seymour.

Wurth makes a similar product. They're in Canada

I'm sure Car Quest or NaPa might be able to get it.

[Pimtao]

Oh...I order it by the case directly from Seymour.

Wurth makes a similar product. They're in Canada

I'm sure Car Quest or NaPa might be able to get it.

Awesome thanks