Author Topic: Convertible Challenger hydraulics  (Read 902 times)

Offline Lotsapins

  • Jr. Member
  • **
  • Posts: 197
Convertible Challenger hydraulics
« on: September 21, 2015 - 08:30:40 AM »
Does anyone have a picture of the pump and hoses hooked up. Not sure how these are to be routed. Pump has been off and hoses are new , so they don't fall into place. Cant find any diagrams on the net so I thought I'd try here. Thanks...
Thanks , Keith
71 Challenger Conv
Build Thread: http://www.cuda-challenger.com/cc/index.php?topic=97569.0
71' Roadrunner Stock restored 383 4spd
08 Charger SRT8 Super Bee
07 Ram 2500 4WD Cummings




Offline CudamanTom

  • Resident
  • *****
  • Posts: 2670
Re: Convertible Challenger hydraulics
« Reply #1 on: September 21, 2015 - 01:29:15 PM »
Keith,

I installed mine this past summer. Even though it's a cuda, the routing should be pretty much the same.
Hope this helps.












And then I made a servicing tool for the hydraulic pump. Took a small funnel, a piece of rubber hose and some spare fuel line and pieced them together. Saved from spilling fluid all over the place.



« Last Edit: September 21, 2015 - 01:38:35 PM by CudamanTom »
1971 Cuda Vert 440-833 - (clone)
1971 Cuda 440-727 - (clone)


Because I like it fast!!!

Offline Lotsapins

  • Jr. Member
  • **
  • Posts: 197
Re: Convertible Challenger hydraulics
« Reply #2 on: September 23, 2015 - 12:57:50 PM »
Thank you... That is exactly what I needed. I wasn't sure if the lines on the rear side of the pump ran out front. I got it working last night and all is good. Thanks again...
Thanks , Keith
71 Challenger Conv
Build Thread: http://www.cuda-challenger.com/cc/index.php?topic=97569.0
71' Roadrunner Stock restored 383 4spd
08 Charger SRT8 Super Bee
07 Ram 2500 4WD Cummings

Offline MOPAR FANATIC

  • Resident
  • *****
  • Posts: 4250
Re: Convertible Challenger hydraulics
« Reply #3 on: September 28, 2015 - 01:04:26 PM »
 :thumbsup: You the man cudaman tom...........
71 Challenger 340 a/t
2013 Plum Crazy Hemi R/T 6SPD