Correct placements for RT and Challenger script on grill ??

[69CHARGERMD]

Are there any measurements or good pics for 70 challenger front grill that shows the placement for the RT badge and Challenger script

[70chall440]

I am sure there is, however I have never see it. The way the badge and grille are, you can put them almost wherever you wish; that said I am sure you want it to look factory, you need a resto guy for that. I centered mine on the grille and spaced slightly from the left side (as if you were sitting in the car). I looked at a lot of factory/period pictures and took a shot.

[TelisSE440]

I have some books about E-Bodies. Most of them show it like this:


The emblems have studs, so just measure the squares on where to exactly put them.

[69CHARGERMD]

Thanks guys,,,,,,

Appreciate the picture Telis !!! 

[jt4406]

I had the same question a while back, got a few varying opinions here:

http://board.moparts.org/ubbthreads/ubbthreads.php/topics/1707355/re-70-challenger-challenger-r-t-grille-emblem-locations.html#Post1707355


Jess

[TelisSE440]

Thanks guys,,,,,,

Appreciate the picture Telis !!! 

 

[msbaugh]

How do these fit on, are they just studs and nuts on the back?  I ordered a repop one online and its just got pointed ends on the back.  They aren't threaded and there's no fasteners or anything

[ChallengerHK]

I think they use thread cutting nuts.

http://www.summitracing.com/parts/rnb-45574?seid=srese1&gclid=CjwKEAiA18mzBRCo1e_-y_KLpXISJACEsANGLgP0YMUqzD4AvngDhFNsk0yGu8iBpPBJ4JnloJqG8RoC44nw_wcB

[dfrazz]

I think they use thread cutting nuts.

http://www.summitracing.com/parts/rnb-45574?seid=srese1&gclid=CjwKEAiA18mzBRCo1e_-y_KLpXISJACEsANGLgP0YMUqzD4AvngDhFNsk0yGu8iBpPBJ4JnloJqG8RoC44nw_wcB

   and they are a pain to put on because the stud has a concave base on the emblem

[TelisSE440]

How do these fit on, are they just studs and nuts on the back?  I ordered a repop one online and its just got pointed ends on the back.  They aren't threaded and there's no fasteners or anything

Like Challenger HK said, these, just a little wider, although they will work...

[filmsurgeon]

Did a bit of research online a while back when I was looking for the same answer.  Found there was nothing really consistent.  I ended up doing mine like one photo I found to be from a "correctly restored" R/T Challenger.  I've attached a photo of my emblem placement.  It's centered, and looks to be the proper distance from the edge of the hoop.

[1 Wild R/T]

Did a bit of research online a while back when I was looking for the same answer.  Found there was nothing really consistent.  I ended up doing mine like one photo I found to be from a "correctly restored" R/T Challenger.  I've attached a photo of my emblem placement.  It's centered, and looks to be the proper distance from the edge of the hoop.

Your R in R/T is just a little low...

[70chall440]

  perhaps a little.