A/C Hoses - WOO HOO !!!

[anlauto]

Thanks for looking

[4Cruizn]

If I had some, are you having them restored or looking for NOS originals?   

[anlauto]

If I had some, are you having them restored or looking for NOS originals?   

Having them restored but the rubber needs to be good

[turbostang7]

Anything from a 70 318 work? I was going to go to vintage air and a big block in it so the entire factory system is there.

[anlauto]

Anything from a 70 318 work? I was going to go to vintage air and a big block in it so the entire factory system is there.

Could you check the part number on the small hose that goes from the expansion valve at the firewall the the drier on the passenger side inner apron, and maybe the hard line from the drier to the condenser ?

I'm thinking big block and small block would be the same.....

I'm going to buy one at a time if I have to....

[turbostang7]

I will check tonight for you.

[turbostang7]

It looks to be a different number, I had parent teacher conference tony but that I forgot about so I will get a closer look tomorrow.
On the hardline, where do you find the number? He one from the expansion valve to the fender seems to be on the crimp fitting and is a little dirty, need to clean some to verify pn on it.

[1 Wild R/T]

71 & up lines aren't the same as 70... The receiver drier changed, it has a female fitting to mate with the male fitting on the line going to the expansion valve... Opposite of a 70....  And starting in 71 the high pressure formed steel line from the condenser to the drier starts on the left side of the condenser instead of the right side like a 70....

71-74 style lines...

[1 Wild R/T]

and

[anlauto]

Good information to know

[manycj]

Alan, not sure if the helps. Here is a picture of the original AC lines from my 318 that I dropped off to Stephan to restore for me. It looks to me that only the lines that attach to the drier are the same for a 383. -Chris

[anlauto]

Yes..The small hose on the left looks the same......Gees...I hope it doesn't go missing while at Stephan's

[Blasterb]

What is this for? I have a 70 383 with AC that is pretty much original. Don't mind looking but don't want to waste my time if that's not what you need

[1 Wild R/T]

What is this for? I have a 70 383 with AC that is pretty much original. Don't mind looking but don't want to waste my time if that's not what you need

If it's truly original that's just what Alan is looking for, Snap a few photo's & post them...

[Blasterb]

Where would the part number be located? Mine are black enamel coated on the pipes. the dryer is aftermarket.would it be on the rubber part?