So it looks like this thread has turned into a build thread, so here is my latest update!
Stripes are here from Phoenix Graphix, the same 1972 stripe it came with. Body shop says they will need it this coming week, so we may see the car home soon!!
Black Friday was a great opportunity to load up on stuff I need, over the last two weeks the following has been ordered/procured:
- Dr. Diff Rear axle shafts w/green bearings
- Phoenix Graphix 1972 Barracuda stripe kit
- Vintage Air non-Factory A/C evaporator kit
- Wilwood 12.88" 6-piston front brake kit (red calipers, drilled/slotted)
- Wilwood 12.2" 4-piston rear brake kit w/parking brake (red calipers, drilled/slotted)
- Wilwood 7/8" Bore master cylinder, EDP coated with combination and adjustable proportioning valve
- Associated Wilwood brake lines and e-brake cables
- Hotchkis E-body front upper control arms
- Hotchkis E-body Front/Rear sway bar kit
- Hotchkis Lower Control Arm pivot/pin kit
- Hotchkis Tie Rod kit
- Hotchkis strut rod kit
- Speedhut custom gauge set [Tach w/speedo, Oil psi, water temp, AFR and fuel level]
- EFISource MegaSquirt MS3 Gold Box (ECU) for 3rd gen Hemi w/harness
- Coleman 1.5:1 steering quickener
