oh.....bother....

[Stacked440]

Well I didn't notice it before but when i was looking at the sides of my challenger up inside the inner fenders, the suspension brace that is shaped like a wishbone that goes from the plate on the inner fender to the top of the inner fender lip...is GONE!  Can't exactly order that from yearone, any ideas anyone?

[71340RT]

You will have to get one from another car as they are not reproduced. I'm sure one of the members has it though.

[Killer_Mopar]

Umm, Im unclear about the piece you are talking about. I thought you were talking about the brace on the inner-part of the fender, but it isnt wishboneshape and doesnt connect to the suspension. The only piece that I can think of is the one I posted in this pic.....but I thought the innerfender-to-firewall brace connected to it, so are you missing that piece too???

[Stacked440]

I have the firewall brace but that circled piece is gone on the drivers side, passenger side still has it.

[Killer_Mopar]

Very weird, wonder why its not there. I have no idea where you are going to find that piece. I think your best bet is to call all the mopar boneyards advertised in MCG. I would imagine that piece is shared between the cudas and challenger or all years, does anyone know for sure?

[Chryco Psycho]

I believe all uda & Challs had them + any 71-72 Bbody should have them also

[moparguy01]

Doesnt look like that hard of a peice to build yourself.  i cant see the front of it, but i cant see it being too complex.

[Killer_Mopar]

Doesnt look like that hard of a peice to build yourself.  i cant see the front of it, but i cant see it being too complex.

The piece is pretty thick and somewhat complex. I doubt he could make anything that resembled the stock piece. If he isnt concerned about looking stock, then it would be pretty easy to fab up a support bracket.

[Stacked440]

I could probably fab it up...just wouldn't like to take the entire evening it would take to make it and put it in.