Author Topic: PVC hose question- calling all original freaks  (Read 917 times)

Offline cooda

  • Jr. Member
  • **
  • Posts: 247
PVC hose question- calling all original freaks
« on: February 26, 2006 - 09:11:18 PM »
For you "original freaks" and "correct geeks": I am putting correct hoses under the hood. Got numbered heater hoses and a PVC hose from Almost NOS in Wisconsin.

The PVC hose I took off was obviously not close to original and the new one is much longer (may mean nothing). But where is the hose routed from the valve cover until it goes into the nipple in back of the carb? There is a round plastic clip near the wiper motor that snaps into the firewall. Does the PVC hose get routed through there? Anybody got a picture of a correct setup? It's a Hemi. but I think any setup would probably be the same.

The picture shows the old hose just curving around to the back of the rear carb, but I don't think that was necessarily the way it is supposed to go. Thanks.
« Last Edit: February 26, 2006 - 09:13:52 PM by cooda »
70 black/black "R" Code Hemicuda, automatic, Super Trac Pac 4.10 Dana, pdb
67 Top Flight Corvette 4 speed silver small block #s roadster
2002 6 speed silver Pontiac Trans Am SLP Firehawk
2008 Red Z06 Corvette
2002 Blue Lexus SC-430 retractable HT- Wife's car




Offline Bullitt-

  • Permanent Resident
  • *******
  • Posts: 12167
  • Better Things To Come Member Since 2/16/06
Re: PVC hose question- calling all original freaks
« Reply #1 on: March 09, 2006 - 09:40:31 PM »

 check w/these guys
http://www.nehoa.org/forum/
Wade  73 Rallye 340..'77 Millennium Falcon...13 R/T Classic   Huntsville, AL
Screwed by Photobucket!