I talked to Hybrid and he was fast and very helpful. (He said to say thank you Steve for the referral)
He can make one but needs to know something: (his email below)
On second thought, for your application, since you will be cutting the center section down so dramatically, I will install a nut on the left and right side of the plate for your cross bar (so the bar won’t interfere with your choke horn) and I will make certain that you can use the two existing nuts (front and rear) for your lid studs. You might have to actually use a 6bbl lid with different spacing in order for this to work (no major difference in appearance). I will see what I can do. I know this may seem confusing, so if you have questions let me know. The problem is, when you cut down that center section and lower the plate down over the carb, the choke horn becomes an obstruction and complicates matters slightly. So instead of running your cross bar from front to back, you would need to run it from side to side.
I have attached a pic of a different plate I sell with the 4 nut set-up to which I am referring (this one happens to be my own personal finished plate, you'll get the idea of how you need to construct the cross bar..
Now if your carb has no choke horn, let me know, because then you can just go with the plate above and the normal 4bbl lid above and I can tell you how to make a special cross bar that would incorporate the lid studs easily and you will be all set.
Now, how do I know or find out if my Demon has a choke horn?
I've attached the photos of his setup. Anyone know what colours I will need to use to paint this stuff?
Hemi Orange and gloss black? or?
Thanks,
Carl
Topic: Chryco, One Last Thing....'Cuda - 69 Air Grabber Help (Read 2096 times)
