73 Challenger Turn Signal Flasher Location?

[MJS73]

Can someone point out where it is?

Thanks,
Mike

[pink panther]

look about half way across the dash (by your vent knobs) on the underneath side  I can take a pic for you if you like.

[fishn4cuda]

I think it's attached along side of the ash tray frame under the dash. The other is close to the steering column on the underside frame close to the fuse box.

[422STROKER]

I like that first pic! Now I know where the flasher is supposed to be!

Tom

[MJS73]

Thanks guys!

Mike

[ShelbyDogg]

Thats where I kept telling Cody to look but his ended up being on the other side o the glove box. So if it's not there on the other side.  Plus I also found an extended connector with an inline fuse to the flasher. Something to check if you don't flash.

[Cuda Cody]

Yep, I think someone might have moved mine over to the other side.  Rob helped me find it.

It did have an inline fuse, but I think it was aftermarket and I'm taking it out. 

[ShelbyDogg]

Cody, I think that inline fuse was a factory fix.  I have one too with the correct connector on one end for the flasher and the other end is a female for the flasher plug. Don't just take it out, just remember that a fuse is there.
It probably corrected a non-fused circuit that fried.

[Cuda Cody]

Good point.

I went and looked and my ash tray and the reason the flasher is not on the side is because the speaker crossover is mounted right there.  Where should the crossover be mounted and is a crossover needed for a 3 speaker dash?

Cody, I think that inline fuse was a factory fix.  I have one too with the correct connector on one end for the flasher and the other end is a female for the flasher plug. Don't just take it out, just remember that a fuse is there.
It probably corrected a non-fused circuit that fried.

[ShelbyDogg]

The crossover box was always used for the 3-speaker dash but I didn't use mine so I don't know where it mounted. I posted some wiring pics a while back from the manual.

[MEK-Dangerfield]

My crossover box was just sitting to the left of the glove box. Sorta right above where the map light would be.

  Mike

[MJS73]

Has anyone seen a 3-prong flasher?  Mine is about 13/16" in diameter, 1-3/8" long (not counting prongs) and has 3 prongs.  The parts stores all say it should be a 2-prong flasher.  I can post a picture, if desired.

Mike

[422STROKER]

Sounds like the key in ignition relay for lights  it's a delay fuse of some sort  I got one on ebay for @10 kind of an oddball to find.

Tom