Up for sale is my 1965 Barracuda project. I have to sell it because of college...I hate to see her go! Anyhow I was driving it as a daily driver until the clutch fork broke. It currently has the original 225ci 6 cylinder with a three on the tree. I have accumilated a V8 K-frame along with a rebuildable 360 and 4 spd 833. It came with the wrong seats so I replaced them with a set from a 66 which looks identical. I have several sets of panels both front and rear, a 4spd steering column along with the quick ratio steering pitman arm, a 9 1/4 rear end out of a stationwagon so it has the big brakes, two sets of disc spindles...it currently has drums, new brake lines(the ones that run the length of the body)$150, A second replacement clutch fork, one set of the upper A arms two sets of lowers, a $200 master brake unit(uninstalled), another drivers side door and a passenger one from a '65 dart,a new carb,a super six intake $238(professionally restored & uninstalled) a fiberglass front valace $300(unistalled),a couple sets of the chrome that goes over the trunk, it's on a faily new set of 185s(less than 100 miles) and a second set of bumpers. The body is a little rough...it needs quarters, and cowl corners. It has all of the chrome. I'm located in New Port Richey Florida
