Author Topic: 70 TA Challenger Hood molding (Read 923 times)

Challenger7405 · « **on:** May 06, 2007 - 12:16:01 AM »

Is the front hood molding on a 70 TA Challenger the same as is on a regular steel hood. Thanks, Eric

MEK-Dangerfield · « **Reply #1 on:** May 06, 2007 - 04:24:19 AM »

The 70 Chally hoods all had the same molding. They have clips with threads on them that mount thru holes in the front of the hood. They are then held on by 3/8" speed nuts. I can dig one up and post a pic for you, if you need to see one.

Mike

Challenger7405 · « **Reply #2 on:** May 06, 2007 - 03:36:19 PM »

Thanks Mike! I was told they were different but I didn't think they were. Eric

MEK-Dangerfield · « **Reply #3 on:** May 06, 2007 - 03:44:12 PM »

Hey, Welcome aboard here.

just my pics...

Mike

Challenger7405 · « **Reply #4 on:** May 06, 2007 - 09:41:30 PM »

Thanks! I'm biulding a 70 Challenger 440 6-Pack NHRA Super Stocker (SS/FA). It's my 1st time at "restoring" a car. Trying to get it to look as stock as possible. It' has a Phill Mandella chassic. It will be Go Mango with a white R/T stripe down the side with white interior. Because NHRA lets us use the TA hood I sold my 70 Cuda and am biulding the Challenger. The car should be out later this year or early next year. Thanks again for the help! Eric

Author Topic: 70 TA Challenger Hood molding (Read 923 times)

Challenger7405

70 TA Challenger Hood molding

MEK-Dangerfield

Re: 70 TA Challenger Hood molding

Challenger7405

Re: 70 TA Challenger Hood molding

MEK-Dangerfield

Re: 70 TA Challenger Hood molding

Challenger7405

Re: 70 TA Challenger Hood molding