Parting '73 Cuda

[koak]

Have complete roof, very clean, $250. Complete Disc brake set-up, $200. 8 3/4 rear, complete. Unsure of ratio. $200. Can deliver to Carlisle. Other E-body parts, inquire or stop by Carlisle spaces M58, 59, 60. koak@echoes.net

[IMNCARN82]

I'm looking for door panels,glass,tailights,seat backs,pass. side A pillar chrome, all kinds of stuff...

[CUDA JAS]

I am looking for the following for a 74 cuda with a small block:

UCA bump stops;
Positive Battery cable;
Trunk floor to filer neck seal;
Filler neck seal;
Transmission Dust Sheild (727)
Starter Splash sheild (plastic cover that goes around the starter); and
ignition coil.

Jason

[71bigblock]

Rear sway bar?   

[pink panther]

22" fan shroud?

[koak]

Guys..negetive on the sway bar, 22" shroud. I do have lots of glass, moldings...etc. e-mail me with specifics

['Cuda Hunter]

  I need both the headlight surrounds. thanks

[Black340]

73 340 valve covers

[AAR71]

 
               Where are you located at? And can you post any pics. of Roof and Disk Brakes?
Thanks

['Cuda Hunter]

  I could also use the front bumper filler that goes inbetween the bumper and the grille.  Passengers side front valance turn signal cover and gasket.  Two speed wiper motor.  3 Rear tail light chrome rings.

[Challenger6pak]

I need the outer and inner drip rail moldings from both sides of the roof.  Thanks.

[1badcuda]

Pass side fender?

[30below]

Rear quarter moldings and trunk molding?Thanks

[challenger71]

rear floor section, under rear seat. I only need the floor section under the seat, not all the rest of that shock mount area. I litterally only need the area with the slats from the footwell area to the area where the mount is for the rear seat.

[1badcuda]

I don't think he's here anymore, I posted mine wanted item a week ago.