Challenger emblem ?

[purple1]

Being that the tailpanel is angled, I would suggest the angled grille emblem to make the Challenger script to sit on a horizontal (flat) level so it can be easily read from behind.

I don't know, but the 71 tail panel is pot metal and has three holes. I'm not sure if it would line up or look right. That and if I did something like that it would look different from the car, and I want them to look alike.

If I can't get a new one I guess I will just use the faded one I got. It's just if I get one later, I have to remove the bumper and tail panel to get that emblem off again.

Dave

[Challenger6pak]

My bad.  For some reason I got in my head that your trailer was a 70. 

[FM3V6M]

I have three marinating in my tool box I'll let go, pt # 3444938, they look identical to yours except only 2 studs ('70?).  The studs look like they line up it just that the first stud on the 'C' is not there.

[purple1]

I have three marinating in my tool box I'll let go, pt # 3444938, they look identical to yours except only 2 studs ('70?).  The studs look like they line up it just that the first stud on the 'C' is not there.

Now that is the part number I have on the new stick on fender emblems... Strange??? 

Top is the 3570519 from one of my 71 tailpanels. Below and far right are the new stick on emblems, both with number 1-P3444938. Now I am realy confused...

Dave

[Lunchbox]

Now that is the part number I have on the new stick on fender emblems... Strange??? 

Top is the 3570519 from one of my 71 tailpanels. Below and far right are the new stick on emblems, both with number 1-P3444938. Now I am realy confused...

Dave

Seems typical of mopar. They found a part that for the most part would work but not exactly like the original. The stick-on emblems I have seen have a 1/16 of a inch or so of foam backing, might stick better then you think with proper prep work  Kind of reminds me of the trunk and quarter trim for the 70 vs the 71-4.

Lunch

[Challenger6pak]

Now that is the part number I have on the new stick on fender emblems... Strange??? 

Top is the 3570519 from one of my 71 tailpanels. Below and far right are the new stick on emblems, both with number 1-P3444938. Now I am realy confused...

Dave

Chrysler used to move part numbers to an "New and Improved part".  I think they changed to the stick on emblems in 72.  I am not sure.

[purple1]

Thanks for all the replies; I am just going to use the faded one. After polishing and re painting the black area around this one, It looks OK.

Dave