sure shawn, ill try my best to explain it.
after final fitment of all removeable panels is satisfactory , i take a small drill bit, i.e. 1/32 - 1/16
and drill 2 pilot holes through the mounting surfaces in a non descript area. take the bit, and another just like it,( or as many as you have) wrap some ample tape around the drill end and save them in a safe location.
this enables you to remove said panels and upon reassembly, all you have to do is take the bits , fit them in the holes, and all panel alignment is thus finished.
its a heckuva lot easier to do, then explain. and no, you cant see the holes unless your looking for them.
and this came directly, and personally from peter klutt, you may have heard of him.
if its good enough for him, im all over it.
now back to our regularly scheduled horror show...
