finally dug out of its grave!!

[wagesofsin]

John that is friggin genius. Now if I could only go back to when my car was original and do that trick. 

PS: I would like to share a piece of your cake. 

 

bwahahahahahahahahahahaha

[mopar12372]

PS: I would like to share a piece of your cake........


buhahahahahahahahahaha

[wally426ci]

PS: I would like to share a piece of your cake........


buhahahahahahahahahaha

Inside Joke. 

[wagesofsin]

got the dash tuned up and back in.
just a cap ,and it fits pretty good , although they forgot to open up the vin area , and i just left the speakers perfed , although my original speakers mounted over the pad.but it looks ok for now.

[dutch]

that cap looks pretty good from here... where did you get it from/ what manufacturer

[wagesofsin]

i have no idea what mfg. i bought it from a guy on moparts a while ago.
it does fit alot better than the one on the challenger.

[dutch]

ok, thanks.
I guess a bit of luck is needed with parts like that too.

[wally426ci]

That cap does look good!! You are gonna have us all using caps with the way that looks!! 

[wagesofsin]

i found the destructions for the cap.

https://www.dashcaps.com/xcart/home.php

on the sheet i have it claims they make interior panels for challys and barracudas... couldnt find any info on the site , but ill call em.

oh and not fer nothing , i use 3m trim adhesive , the high strength , not the stuff they supply.

[dutch]

these glue right on top of the original cap?

[wagesofsin]

these glue right on top of the original cap?

yes .

you may want to actually trim off some of the cracked bits , or warped areas , fit , then trim , fit, etc. when it looks good , get a pile of bungee chords , and some 3m high strength trim adhesive. you want it to suck on good front to back, and then pull on an angle towards the back , then straight corner to corner across the back. wait 24 hours, and viola...


hopefully. 

[dutch]

    

gonna be fun shipping... 

[wagesofsin]

   

gonna be fun shipping... 

if in fact you want one, lemme know, i can get it for you and ship it cheaper.

[quapman]

I've done a few of these caps on E and B bodies and as wages suggests, use a good, quality contact adhesive and save the silicone to seal your bathtub.

The Palco interior panels are the ones everyone here on the board complains about being low quality and the wrong grain. I'll let you know when I finally install the set I bought  a couple years ago.....

[ShelbyDogg]

Be careful about gluing it too much. It should only be glued on the edges and around the open holes. When the sun hits it and your windows are rolled up, that cheap plastic starts expanding and shrinking.
That's funny that yours has perforated speaker holes. Are they right over the original speakers? They look like they are too far too the center.      I have a cap where the CENTER SPEAKER is just perforated holes, but the outside speakers, I was able to cut the holes and install the 3 speaker grills.

I use the silicone that comes with the caps. I use those binder clips that you get at the office supply store or in your office's supply cabinet.