I'm finally starting the next project.. THIS IS DONE!!!!!!!

[BIGSHCLUNK]

Back to console reconstruction too...

[BIGSHCLUNK]

I started filling in w jb weld renforced w grooved wire... very time consuming. But trust me, when its done , it'll look good an be strong! 

[BIGSHCLUNK]

I put the new belts in and started on the rear carpet section tonite. Man that first cut is nerve wracking!!     Then I poped the holes for the belts a little high so I could pull it down on the hump to get it tight! Seems to be ok so far...   then I tought enuff for tonite... quit before I screw up!! 

[BIGSHCLUNK]

Carpet pretty well in!!    Doin that first cut over the shifter is scary stuff. 

[BIGSHCLUNK]

I read somewhere that ACC carpets were too short or something. That has NOT been my experience. I got carpet up the yinyang here!! But I think it's lookin pretty good!   

[BIGSHCLUNK]

The hardest part of the carpet was cutting the dimmer switch hole!! Everything has tucked up under the das really nice. It's all reassmbly from here. 

[todd383]

  lookin great!!!

[farmertan]

AAhhh new carpet, will you be able to hop in and drive the car with your shoes on?

[BIGSHCLUNK]

Hey I got the back seat and rear panels back in,  Started on the console too! Hope to be about done today.. 

[JS27N0B]

looks like I've been away for too long! You have been busy.

[wagesofsin]

looks great!!!

 

p.s. i got the carpet, thanks again.

[BIGSHCLUNK]

Thanks guys! New seat backs lookin' good! I've been plaing with the console about 2 hrs and took a lunch break. To get things to sit properly I'm finding out is a bit of a project! I had to pull some of the jute backing out around the shift hardware to get the console to sit a little lower. But I think I finally have the shift plate lined up ok. The line in the "PRND21" is a bit off, but I think thats due to the new Shumacher mounts along with the new trans mount. Things are sitting a little different. I can live with that for now.   

[Street_Challenged73]

Very nice progress!!!

[BIGSHCLUNK]

Thanks Mark. Well I did it!! This part of NIKKI is DONE!!!!!    I'll bet I had that console on and off ten times before I got it where it needed to be, but I think the results look pretty good. I even did a quik polish on my sill plates. They wern't perfect to begin with but look much better now! 

[BIGSHCLUNK]

Tomorrow it's time to go cruzzin!  I'm not working on ANYTHING!!!   


But I am thinking of her next upgrade.... Steering!! 

A few members helped out on this,,, JAYBEE / HEMI ORANGE / 340 (Jeff) for sending me a few needed freebies!! Also parts from quapman (steve) and mopardave!