News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: Z-Bar Greasing Procedure?  (Read 831 times)

    Offline cwestra

    • Sr. Member
    • ****
    • Posts: 1120
    Z-Bar Greasing Procedure?
    « on: September 07, 2009 - 07:50:18 PM »
    I am rebuilding my Z-bar.  I have the kit with balls, seals, etc...  Do I need to grease the nylon bushings before I install the kit or not?
    Logged
    Corey - in Northern Indiana


    Offline Moparal

    • Permanent Resident
    • *******
    • Posts: 13085
    Re: Z-Bar Greasing Procedure?
    « Reply #1 on: September 07, 2009 - 07:52:09 PM »
    yes, grease them up, then put the flat fiber seal and rubber grommet in place to keep the grit out.  There is a lot of pressure on those ball cups
    Logged
    Pages: [1]
    « previous next »