Parting out 74 Barracuda & 70 Challenger

[Cuda1971]

Do you have window regulators and brackets (side and quaters)for cuda perhaps?
Thanks and
Merry Christmas
Roger

[brads70]

 I'm looking for the fuzzy window regulator that the pen is pointing too that's held on with 2 screws?

[Canadian Cuda]

i need one of the studs in the upper rad support for hood latch plate and two of those little square nuts for attatching the radiator to the rad. supprt, do you have them?

[vpittman]

I'm looking for a passenger side wiper arm, if you have one...

Thanks !

[knk-mopar-parts]

Do you have the a pillars and the cross piece that goes on top between the a pillars? I don't know the correct name? I guess i need the entire structure around the windshield except the bottom cowl area.

Already gone!!!!!

[knk-mopar-parts]

Do you have window regulators and brackets (side and quaters)for cuda perhaps?
Thanks and
Merry Christmas
Roger

Hey  Roger I do believe I have everything you need for both 1/4 windows and both door windows. Where you located? Thanks Kevin

[knk-mopar-parts]

I'm looking for the fuzzy window regulator that the pen is pointing too that's held on with 2 screws?

I think I have them but dont know condition until I check on them. Thanks Kevin

[knk-mopar-parts]

i need one of the studs in the upper rad support for hood latch plate and two of those little square nuts for attatching the radiator to the rad. supprt, do you have them?

I will check and see...Thanks Kevin

[knk-mopar-parts]

I'm looking for a passenger side wiper arm, if you have one...

Thanks !

Yes I will check condition of it.

[knk-mopar-parts]

are your wheel well areas toast? I could use some patch work. thanks.

They are pretty rough, what area do you need?

[knk-mopar-parts]

Hey IMNCARN82
 
dont have what your looking for

[Topcat]

Hi Lo Prestolite horns working?

[stephenlocke]

Hi,

How rusted it the bottom front window section, I have a couple of rusted out parts on my 70 that I need to patch.
These are both near the 2 windshiled wiper mounting holes.
Let me know.

Thanks

Steve

[Cuda1971]

Hi,Great I have send a PM.Do you know if 74 regulators same as 71?
Thanks.
Roger
I have send you a mail.Pm didn't work.

[femtnmax]

Hi - for the front sway bar, do you have the two U-shaped brackets that hold the rubber blocks at the front of the sway bar?  I'm not talking about the thick straight pieces that bolt to the K-frame.
Also, for the 70 chally, do you have the hood safety latch that bolts to the underside of the hood?  Has the spring loaded hook and you lift "up" on the flange that sticks forward.  If so, I'd also need the two bolts/washers that hold the latch to the hood.   Thanks.  Phil