Tons of pics in this thread:
http://www.forabodiesonly.com/mopar/showthread.php?t=78737&page=2Now, the fenders have been stripped, so that's why they look so bad - they are actually VERY straight and only the passenger side has a few small rust pin holes behind the wheel well - you can see in the one pic. The passenger has surface rust, but nothing that can't be lightly sanded off in a couple minutes. The driver has no rust.
The floors are very solid, they look orange, but the only holes are a few very small pin holes in the front passenger - right where it meets the trans tunnel - you can see in one pic.
I forgot to bring the trunk keys with me, so I'm sorry that I didn't get pics of inside. However, the trunk and trunk extensions have holes and need to be replaced. The deck lid is only lightly bolted to the hinges, that's why it's popped up by the springs in the back - the lid is straight w/ no rust.
The tail panel is solid as you can see - as is the rear frame crossmember behind the bumper.
The window channel in the rear will need to be replaced w/ a new dutchman panel or patchwork. Really the corners and a few inches in are the worst.
The real beauty is underneath - you can see the frame rails are rock solid, and the undercarrige as a whole is very clean.
Engine compartment is rock solid.
The rear "C" pillar on the driver's side is NOT damaged, it's just been scrapped and stripped and looks ugly. It's straight and there's no rust there.
Doors are solid w/ no rust, as are the rocker panels.
You can see in my attic are all the parts stripped off the car - labeled and bagged. even the screws. The cars complete except the underhood A/C components, front windshield (sorry, broke in transit), interior door panels, and radiator.
comes w/ extra instrument bezel core, and radiator support (the original, with vin stamp, is fine, but a little bent - can be straightened, but I got a nice straight one at a good price).
Comes with, but not limited to:
-front bench
-rear seat
-complete dash-tail lights
-dash harness
-seat belts
-440 HP block short block
-YO repro 6 pack hood
-MINT side scoops. NOS, but have been painted (have never even been drilled for the bezels) I overpaid, but they cost me $1k
-screws, bolt, etc.
-interior heater - A/C box
-727 tranny
-8 3/4 rear - not sure what gears or if it open or not
-grille, headlight bezels
-window trim
-interior pillar trim
-sill covers
-dash pads & bezels
-tail panel
-side scoops and template
-etc, etc.
This car needs:
Trunk
trunk extensions
quarters (at least the lower half)
patchwork or replacement dutchman panel to fix the rear windshiled channel
VERY small pin hole repair to passenger front floor board
Pin hole repair on passenger fender behind wheel
various dings and prep work
Fender tag:
B3 car
white stripe
power brakes
light group
manual driver mirror
3 speed wipers
air w/ heat
AM 8 track
26in radiator
split bench w/ cloth and vinyl
$4000.00 takes it all.
