Vinyl trim for Chally - this don't look right

[BB73Challenger]

OK, so the trim clips on the end were breaking and coming up on the Challenger,
I am going to help a fellow member out and long story short I opted to go ahead and
remove the trim, and replace the bad clips.... when I find this!



This is not correct is it - I have looked up R/T spec and see they have new ones available, and there is no
screws or washers in the pic.

[Bullitt-]

Should be little metal studs with a head like a nail.. I think they are avail. through body shop suppliers ....See pics in this thread http://www.cuda-challenger.com/cc/index.php?topic=62192.0

[wally426ci]

70/71 had clips with threaded studs, yo may need to go that route since this ones drilled out, but the trim is slightly narrower.

[quapman]

You can use the smaller version of this clip also:

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=310092135300&viewitem=&sspagename=STRK%3AMEWAX%3AIT

[CHL2T]

OK, so the trim clips on the end were breaking and coming up on the Challenger,
I am going to help a fellow member out and long story short I opted to go ahead and
remove the trim, and replace the bad clips.... when I find this!



This is not correct is it - I have looked up R/T spec and see they have new ones available, and there is no
screws or washers in the pic.

Thanks for the picture I was going to buy new trim clips for my vinyl top trim, saw your picture and used the same setup, worked great, and saved on a purchase and shipping. After all, it is the Ratty R/T and I am the king of backyard, on the cheap, Mopar fixes