Washer Bottle/Pump/Hoses/Squirters Drawing or Picture for 70 Challenger?

[1970 RT Challenger 1970]

Is there a Drawing or Schematic for this?

Does the Electric Pump Outlet face forward?

Even a pic from someones car would be great. Thanks

[Chryco Psycho]

the factory service manual should have an illustration , the motor on the bottom of the washer bottle usually faces the rear of the car , the hose to the hood goes through the hole in the cowl lip above the wiper motor , there is a special Tee that snaps into the hood & send the fluid out the the 2 squirter pipes screwed to the under side of the hood that poke through the grille at the back of the hood

[1970 RT Challenger 1970]

I have the complete kit to install:

Which path does the hose from the washer bottle/pump follow:

1. To the battery area then the vacuum booster/master cylinder
and then to the hood center?

2. Straight back to the passenger side windshield and to the center of the hood?

Thanks.

[Chryco Psycho]

it comes up behind the horns & goes back on the passenger inner fender , across the firewall clips & up behind the wiper motor & through the hole in the cowl lip to the tee in the hood

[BIGSHCLUNK]

I can take some pics if you like.... altho my wiper motors currently out...

[1970 RT Challenger 1970]

I can take some pics if you like.... altho my wiper motors currently out...

Pics would be Excellent, Thanks!

[ShelbyDogg]

My electric pump outlet faces down towards the framerail.  The motor housing faces the firewall.

[BIGSHCLUNK]

Pics would be Excellent, Thanks!

Crap... forgot about this, I'll try for tomorrow... 

[1970 RT Challenger 1970]

The plastic tie wraps in the hose kit push into the holes on the inner fender? Thanks

[Alaskan_TA]

Different types of pumps were used, from memory there are at least three types for 1970 E body models alone. Not all of them face the same way.

[ndrewoods]

Is there a Drawing or Schematic for this?

Does the Electric Washer Pump Outlet face forward?

Even a pic from someones car would be great. Thanks

Bumping an old thread. Kinda need a schematic for this as well. Need it for my washer pump. Anyone here has one? Appreciate any posted pics.

[Matt70]

Here are some pics, screw driver is on the washer fluid line. Hope this helps.  Matt

[DAYLEY/CHALLENGER]

Hey Matt...... Looks like you have a lot of orig . equip under the hood.  Nice pics too of the routing.  I am missing the T part...............

[Matt70]

Hey Matt...... Looks like you have a lot of orig . equip under the hood.  Nice pics too of the routing.  I am missing the T part...............

Hey Dave, yeah thanks. It was a 318 now a 360, but I think a 440 is in it's future  I'm jealous of your RT/SE 
Take it easy,  Matt

[quapman]

I've never seen the hose go through the hole in the wiper motor shield.