Anyone have pics of stock HEMI dipstick tube routing?

[BIGSHCLUNK]

I guess the title says it all.  A bazillion pics I 've got but nothing like this.    Man I'd like to get this done before the weekend!    THANKS

[Topcat]

Third pic in the middle Bigs

http://www.mmcdetroit.com/ICCA/References/Hemi_Engine_Paint/

Problem lies that if the Schumachers are used, there's interference having it exactly like this.

[BIGSHCLUNK]

Thanks for posting that Mike. I dont think the tube I got would make it that far. I hope someone has got more of a underneath or low side angle shot. Man this has been a PITA! I'm trying to keep things simple as poss..    ... and I'm pretty thinned out on top as it is! 
I've come to the conclusion, dropping the ext man again is the only way I'm getting this done... 

[Topcat]

Good luck. Can't wait to see how it works out w/the Schumachers.

BTW, your inbox is full. 

[BIGSHCLUNK]

Mailbox cleaned out! 

[BIGSHCLUNK]

Someone onD-C threw up a pic for me (very cool). His tube is sort of over the manifold versus Mikes pic that more follows the contour on the bottom. looks like either way Ext-Man comes back down tomorrow... 

[Topcat]

Someone onD-C threw up a pic for me (very cool). His tube is sort of over the manifold versus Mikes pic that more follows the contour on the bottom. looks like either way Ext-Man comes back down tomorrow... 

Got a pic of it Bigs? I expect a somewhat of a challenge getting it around the Schumacher mount.

That pic is with the factory mounts/bracket/ K member. So it's going up without any interference.