Author Topic: Overdrive Question  (Read 768 times)

Offline Slotts

  • Sr. Member
  • ****
  • Posts: 1893
Overdrive Question
« on: July 15, 2010 - 02:51:47 PM »
Eric's 99 Dakota has a 318 4WD auto and noticed on the trip to and from Carlisle that it would only go into overdrive when first getting on the turnpike. Once in overdrive and then if it downshifted, it would not go back into overdrive. The check engine light is not coming on.

Thank you for any help.

Slotts




Offline ntstlgl1970

  • Resident
  • *****
  • Posts: 2204
  • T a c o c a t
Re: Overdrive Question
« Reply #1 on: July 15, 2010 - 03:11:38 PM »
First thing would be to determine if the computer is electrically commanding the trans to come out of overdrive or if there is a mechanical /solenoid issue in the transmission itself. Trans connector Pin 6 (brown wire) is the one for the overdrive solenoid. The computer will ground the brown wire to energize the OD solenoid. Should be pretty straightforward to check this with a DVOM.
70 Cuda, 7.0L Gen-III Hemi, Viper T56 w/9310 gearset, 3.91's, Megasquirt MS3x v3.57, Innovate wideband, Firm Feel upper arms, torsion bars, springs and strut rods, QA1 DA shocks. I did everything on this car except the fancy paint stuff and I drive it...and I can't seem to stop messing with it....

Offline Slotts

  • Sr. Member
  • ****
  • Posts: 1893
Re: Overdrive Question
« Reply #2 on: July 15, 2010 - 09:20:10 PM »
First thing would be to determine if the computer is electrically commanding the trans to come out of overdrive or if there is a mechanical /solenoid issue in the transmission itself. Trans connector Pin 6 (brown wire) is the one for the overdrive solenoid. The computer will ground the brown wire to energize the OD solenoid. Should be pretty straightforward to check this with a DVOM.

Thank you very much for the help and I will look into this. I appreciate it.  :2thumbs:

Slotts