OK, I'll fess up.
They arrived today. They seem OK, but it's a little intimidating at this point since I have to hack into the existing rear harness to find out what wire does what. Then I was led to believe the power wire for the control board would be long enough to reach the fuse box. This is NOT the case. I have an aftermarket amp in my trunk that I will tie into that has a fused power source. These wires won't even reach it, so I just want to throw that out there.
You have to figure in the "Mike" factor here. Any job that I think will take 2 hours, will have to be multiplied by 4. So I will try installation this weekend, but I know it will take far longer than I expect.
Brad, Just for you, I have gotten my original tail light lenses out and buffed the heck out of them. I will install these in place of the repro things I have in there now.
Mike