News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: Canton OIL ACCUMULATOR for My Hemi - Any Opinions?  (Read 483 times)

    Offline EbodyPro572

    • "Always restore, NEVER discard!"
    • Jr. Member
    • **
    • Posts: 129
    Canton OIL ACCUMULATOR for My Hemi - Any Opinions?
    « on: November 14, 2010 - 12:16:10 PM »
    I want to purchase the Canton 3-Quart Oil Accumulator for my 73 Challenger w/572 Hemi. It's has an aluminum World Block and I'm not sure where to plumb the accumulator on the block. Front, Rear, not sure???
    I want to use it as a pre-luber too and possibly use an oil cooler, remote filter, oil thermostat valve too, since i think you can purchase that stuff through Canton.
    Any help and/or suggistions/opinions out there? Want to do this right!
    Thanks, scott
    Logged
    'ALWAYS Restore.....NEVER Discard'
    73 Challenger; 04 Rumble Bee (Yello, of course); 01 Vehicross (Yello, of course, too); 90 Allante' (not Yello, just red); 79 MGB-V8; 68 Century Resorter;
    73 Marlin Ski (468" Olds) Jet Boat; 06 Harley Fat Boy CVO; 73 Yamaha Golf Cart (Yello, of course); 07 Sears Garden Tractor


    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: Canton OIL ACCUMULATOR for My Hemi - Any Opinions?
    « Reply #1 on: November 16, 2010 - 11:15:27 PM »
    the coolers I have seen plumb in between the oil filter & oil pump housing on the big blocks

    the prelube can be connected to the block plug beside the oil pressure guage in the rear of the big block , it will feed the lifter gallery & mains from there
    Logged

    Challenger - You`ll wish You Hadn`t
    Pages: [1]
    « previous next »