ok , im sold ! the indy rockers from them are good too..
The rocker arms that I have sitting out side are the Indy 1.6 ratio aluminum roller rockers. I like them except for the fact that 13 out of 16 are messed up and can't be used... I still have both shafts, stud kit, and spacers though... The stud kit I'm gonna reuse, but all else I'd rather replace than be sorry down the road... Now with this being said, the guy I got them from didn't know they were messed up, he went to T&D rocker arm set up because he added a bit spring pressure... When they first came in, they looked nice, when messing around under a Flouresent tube light, the cracks jumped out big time, the majority of them were actually cracked by the roller that rides the valve, but a couple were cracked at the adjuster (most common area). The guy who I got them from didn't realize it, was gonna make it right by sending me the other set he had until he got to looking at his others one, and found them to be in the same condition, he'd never seen them crack at the roller tip like they did.... Either way, he made right and have nothing but good things to say about him, and I would hold no reserve against dealing with him and hope to again later on.
Either way, it don't help my current situation lol. I got to have the set of rocker arms that I'm gonna run so I can figure out what length pushrod I need, also the Indy's are ball/cup design, but not all roller rocker arms are the ball/cup design (obviously) so.... And no, I
want run the factory pushrods that were in it...
This is why I got to figure out what to run, but it will have to be a 1.6 ratio, and I do prefer the roller rocker arm design... Don't know why the r.r. design, but I do
