Engine is complete

[67vertman]

I picked up my motor from the engine builder today.

It's broken in and we did some dyno pulls.

The numbers are 493.8 hp at 5200 rpm and 513 ft lbs of tq.    Just where I wanted it to be.

I will post the dyno sheet later.





And a photo of the motor with the EFI system set on top.

[MEK-Dangerfield]

Sounds good Ron.   

You going with a black painted engine?

[BIGSHCLUNK]

Ron, I dont care what color it is       Nice pulls, I bet you cant wait to run'er! 

[Strawdawg]

It looks really good!

[DoNotChallengeHer]

Ron, That's awesome. Feels good when your getting close. 

[moparmaniac59]

Nice numbers. Clean motor!! 

                             

                                                              Matt B.

[SMS]

I am lovin that EFI set up.

 That is going to be a blast to drive.

[67vertman]

Sounds good Ron.   

You going with a black painted engine?

I think so, I am going with a black car and I am afraid that the orange will standout to much. 

Ron, That's awesome. Feels good when your getting close. 

Thanks Jackie!  It close......but not close enough.....yet!

I am lovin that EFI set up.

 That is going to be a blast to drive.

Thanks, I can't wait to see how it will respond with the EFI set up. 

[mojavered]

What intake and carb did it run with?

[dutch]

that black with aluminum will look great in your car 

[67vertman]

What intake and carb did it run with?

They ran it with a M1 intake and a Holley 950 cfm, and 1 3/4 hooker headers with a 2 1/2 inch collector.

[67vertman]

nice 6 pack setup! congrats! 

Thanks Jason.

My engine builder built a 360 for Car Craft magizane.  It made 628 hp, and should be on the news stands arounf Nov.  I can't wait to see what your motor runs.

[RB2929]

6-PAK EFI!?!
That's badass

[Topcat]

Gonna rip chunks of pavement with that. Looks great.

[67vertman]

Gonna rip chunks of pavement with that. Looks great.

Thanks Mike!

It's not like your Hemi is going to roll over and play dead either.