More info on getting the stripes painted:
http://kelleyhome.homestead.com/cybercuda.htmlKEY:
A = 20" UP from hood edge (nose side). 9 5/16" between red areas
B = 39" UP from hood edge (nose side). 9 9/16" between red areas
C = from bottom vent corner (passenger side vent hole; hole closest to middle of hood). 11 1/4" to red
D = 11 1/4" from hood lip (windshield side) to red. ** (Align togther with point 'C')
E = 9 3/16" hood lip (windshield side), going over 6th vent (from center of hood) hole
F = 9 10/16" hood lip (windshield side), going over 13th vent (from center of hood) hole
G = 10 10/16" hood lip (windshield side), going over 5th vent (from driver's side fender) hole
H = 15 3/4" from CORNER of hood lip (windshield side) to red ** (align together with point 'I')
I = 46" up from hood edge (nose side). 9 1/4" IN from hood edge (driver's side fender edge)
J = 36" UP from hood edge (nose side). 6 15/16" from edge to red
K = 25" UP from hood edge (nose side). 6 13/16" from edge to red
L = 13" UP from hood edge (nose side). 6 13/16" from edge to red
M = AT hood edge (nose side). 6 11/16" from edge to red
1 = 4" UP from hood edge (nose side). 6 11/16 from edge to red
2 = 21 1/4" - from edge to far side of first 'red' scallop
3 = 30 9/16" - from edge to near side of 2nd 'red' scallop (not pictured)
4 = 45 10/16" - from edge to far side of 2nd 'red' scallop (not pictured)
5 = 52 1/8" - total width of hood from driver's side to passenger side (not pictured)
# 3,4 & 5 are not shown on picture, but would be a continuation of the line between
points #1 & #2. This 'line' was measured starting at 4" above the hood egde (nose side)