Best oil pan gasket?

[brads70]

I'm building a 451" and was wondering about oil pan gaskets? Does anyone have a molded silicon rubber type gasket with the steel inserts for the bolts ( so you can't over tighten it?) Used lots of this type of gasket in SBC engines but don't know where to get one for a BB Mopar?
I'll be using the Milodon road race pan if that matters?

Same design valve cover gaskets would be good too if anyone knows of any?

[Chryco Psycho]

FelPro has a premium oil pan gasket , I guess I should have included it with the pan , I think it is $60 or so , you may need two & I would install a crank scraper as well

[brads70]

FelPro has a premium oil pan gasket , I guess I should have included it with the pan , I think it is $60 or so , you may need two & I would install a crank scraper as well

Would you happen to know the part #?
Would this be useful? Or will Milodon have a crank scraper?
http://www.ebay.com/itm/390361507888?_trksid=p3984.m1423.l2649&item=390361507888&viewitem=&sspagename=STRK:MEWAX:IT&vxp=mtr

[brads70]

Found this!   Is this what your meaning?
http://www.jegs.com/webapp/wcs/stores/servlet/ProductDisplayPopup?storeId=10001&catalogId=10002&productId=746664&itemId=90582&langId=-1&showValue=1

[Chryco Psycho]

looks like the right gasket , I would just make a crank scraper out of cardboard as a template & weld it onto a windage tray
 yes the windge tray is helpful as well

[72cudamaan]

looks like the right gasket , I would just make a crank scraper out of cardboard & weld it onto a windage tray
 yes the windge tray is helpful as well

A little too much rootbeer for ya Neil?  Weld a cardboard scraper to
the windage tray? You crack me up sometimes.  Though yes, I know what you meant.

[Chryco Psycho]

special cardbaord that resist oil & can be welded 

[Cooter]

Best pan gasket that I have ever used is Silcone.