News:
It is a Barracuda, correct. But the callout sticker is re-production and this is not the original dash cluster. I do have the original unmolested dash if you would like me to look? This car has less than 30k original miles and my original dash is virtually MINT.
What I really want to know is where you got the re-production sticker?
http://www.performancecargraphics.com/Dash_Stuff/Switch_Labels/E-body_Standard.htm
Could always use one of these:http://www.classicindustries.com/mopar/parts/mb1847.html
Been meaning to post a few pics on my dash progress. I wasnt happy with the way Rocky mountain made the switch panel area.....there was no way of making it look good . The switches all stuck out way too far and just looked terrible...so I chopped up some 2" quarter inch alumn square tube and cut it the proper angle and tacked in down. This was of course after many tedious measurements to ensure the switch protruded out the proper amount. So I could now mount the switches and they look much nicer this way. I had to swap the dimmer and wiper switch around for clearance issues on the backside. Now...Im Just waiting for my new wiper switch to show up in the mail to complete the switch panel area...Other mods I made were machining a recessed bezel for the switch label (which i will make once painted), and heater controller slots/mounting brackets for heater and a little light slot to illuminate the heater panel.
Yeah, buts its got a very goofy layout: http://www.classicindustries.com/mopar/parts/me1596.html
no kidding I can't imagine putting that idiodic looking think in an E body... so does anyone know forsure if the B body dash fits?
