how to remove driver's seat

[hooD]

My driver's seat has some splits in the seams.  Only the seat...not the back rest. 

How do I remove the bucket seat so I can take it to the uhpostery guy.

Step by step would be great for this old fart.....thanks!

[MY J0B]

Look underneath for four 1/2 nuts. Remove them and you're done.

[72cudamaan]

To remove the seat back, there are two bolts hidden under the hinge covers.

[Katfish]

 That's where Ford got it right.  The bolts on my 06 Mustang are inside car.
No need to crawl under car to remove the seat.

[JayBee]

You'll need a deep socket (1/2 inch), the studs are pretty long.

[MEK-Dangerfield]

Unfortunately, you have to remove the seat from the car, and separate the seatback from the bottom.

[hooD]

You'll need a deep socket (1/2 inch), the studs are pretty long.

four of these right?
does that square plate come off too?

[brads70]

four of these right?
does that square plate come off too?

Yep that's them. On mine those plates stayed on the car.

[dvldwg89]

Just curious. After removing the front seats is it hard to put th em back in?

[Katfish]

No, just awkward lining the bolts up to drop the seat in.
Usually have to wiggle the seat around until it drops in place.

[dvldwg89]

Cool. Thanks .

[Jamiez]

They are a lot easier to handle if you separate the top and bottom of the seats.

[Skunkworks Challenger]

They are a lot easier to handle if you separate the top and bottom of the seats.

If fold the seat back forward and tie it to the seat with a small rope to make it easier to handle while removing from the car.  You can reach the four bolts just by laying on the floor beside the car.

[dvldwg89]

They are a lot easier to handle if you separate the top and bottom of the seats.

What's  involved in seperating the seat tops from the bottoms?

[GranCuda1970]

Out is easier than in ! My floor panel kinda had some spring to it after the seat came out but when I put the seat back in it tightened everything back up.