Check your headlight fluid!!

[moparmaniac59]

I was checking my headlight fluid this morning and noticed my muffler bearings were bad. Anybody know what size I need??




                                                                             Matt B.

[ChallengerHK]

That looks to me to be about .005 of a rod in diameter, but it's been more than a fortnight since I looked at the reference so I might be wrong.

[70CUDA4SPEED]

They are same size as 8 3/4 carrier bearings, I changed last week, muffler still looks good so it was worth it.

[moparman82]

 :dupe:as long as your doing that you should check your carburetor fan and blanker fluid.  It's also very common in these vehicles to have flux-capacitors that are discombobulated

[burdar]

There's no way I'd put a bearing in that muffler...it's shot.  Replace the entire thing.

[ChallengerHK]

There's no way I'd put a bearing in that muffler...it's shot.  Replace the entire thing.

If you look closely you'll see that that's the very rare Hemi T/A muffler. I don't think you'll be able to find one nowadays, so if will have to be restored.

[burdar]

Isn't ECS coming out with factory exacty exhaust systems?  I'm sure Dave is ontop of this.

[HP_Cuda]

Make sure to replace it with the new and improved chrome muffler bearing!!!

[MOPAR FANATIC]

  Here ya go........ N O S PART#4645912. Have three in my garage at home,since they are NOS I'm going to have to get at least $500.00 for it. 

[70CUDA4SPEED]

Here ya go........ N O S PART#4645912. Have three in my garage at home,since they are NOS I'm going to have to get at least $500.00 for it. 

I have never seen a car with 3 mufflers??

[MOPAR FANATIC]

I have never seen a car with 3 mufflers??

  I sold one to a guy down the street with a 70 chally six banger so thats why i have three left,shouldn't have broken em up.nom i'm going to be short one for you guys with those dual HEMI mufflers.and by the way that price is per bearing. 

[moparmaniac59]

I think I need to exchange my O2 sensors for the new 'BS' detectors. 


                                                                             Matt B.

[MTS-Challenger]

Be sure to use lefthanded allen wrenches when replacing the bearings.
 

[brads70]

Don't forget the fur lined overhead roof mats and the his and hers push pull ashtrays.

[AARuFAST]

Hed lit  Remedy to remove moisture drill 3 to 5 spaced
 5/16 holes in lens.