Attaching rear valance to '72 'Cuda

[mrbill426]

My rear valance was welded to the rear quarters    by a previous body shop.  I am getting close to installing a new one onto  the new quarters but am unsure of what fasteners to use.  It looks like it would be the same size bolt/washers and U-nuts that are used on the front fenders, is that so?  Are there any brackets or is it a straight bolt-in?  Mine has exhaust tip cutouts if it make a difference.

Thanks

[anlauto]

The rear valance uses 1/4-20 studs and nuts along the side, and 4 screws along the top. You can get a rear valance hardware kit pretty cheap.

[mrbill426]

Hey, thanks! 
Any brackets or is that all there is to it?

The rear valance uses 1/4-20 studs and nuts along the side, and 4 screws along the top. You can get a rear valance hardware kit pretty cheap.

[anlauto]

Two brackets in the middle below the license plate

[CudamanTom]

I just installed mine last night on my 71.

Here is the bolt/screw kit I purchased, Worked perfectly too.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&vxp=mtr&item=231222180987

[mrbill426]

Thank you, much appreciated 

I just installed mine last night on my 71.

Here is the bolt/screw kit I purchased, Worked perfectly too.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&vxp=mtr&item=231222180987