cuda rear tail trim clips/fasteners etc

[culp71]

hello all,

could someone clarify which clips go where, in a 71 cuda tail panel trim.
I have 12 plastic clips w center pins, 2 metal door like clips w rubber inserts and four metal tab brackets.
first off are these correct?
If so where do each style go?

thank you

[anlauto]

The plastic ones look correct....all others...not so much....

This is what you normally use:

[culp71]

ok, that would make a difference.
I would assume then that the plastic "H shaped" clips get used on top and bottom center strips,
and the corner pieces use the 3 clips w stud and nut  (per side).

right?

[anlauto]

ok, that would make a difference.
I would assume then that the plastic "H shaped" clips get used on top and bottom center strips,
and the corner pieces use the 3 clips w stud and nut  (per side).

right?

YES