Source for fast ratio idler arm?

[torredcuda]

I`ll have all the details once I have it installed to make it clears headers etc. but not sure when that will be since the GF is having contractions!

[ToxicWolf]

I`ll have all the details once I have it installed to make it clears headers etc. but not sure when that will be since the GF is having contractions!

Good luck with that contractions thing.   

[torredcuda]

Napa 268-3467 or

Cross Interchange Parts

Factory          Number

MOOG K7014
AUTOSPECIALTY 09-83004
ELGIN 8669K
SEALED POWER 803-18669
CHRYSLER 2269679
CHRYSLER 2835842


Ok, it fit but not without a struggle. First problem was the shaft that mounts on the k-frame wouldn`t fit so I had to grind off about 1/16". Not sure if it was due to  the thick washers supplied or the c-body is supposed to be longer? Once I got that fixed I bolted it up to find out the grease fitting is placed on the end and hits the header tube so I had to drill a new hole on the drivers side of the knuckle and weld up the original hole. It`s now bolted in and clears everything fine although I voided the lifetime warranty by modifying it but oh well.

[torredcuda]

http://www.napaonline.com/Catalog/CatalogItemDetail.aspx/Idler-Arm-Assy/_/R-NCP2683467_0131112444

[Katfish]

Not clear on where you had to grind the 1/16"

It was too thick to slide inside the K-frame jacket?
Or was too deep?

Got a pic?

[torredcuda]

The sleeve/tube that the bolt goes thru. I ground 1/16" off the length. I could have also used a thinner washer but I believe they are hardened and didn`t just want to use a regular one.